Collet chuck is stuck quite hard. Are there any little tricks to loosen it?
Q Collet chuck is stuck quite hard. Are there any little tricks to loosen it?
A Please refer to the following procedures;
- Please turn the set ring hard to R- direction(be able to release the tool).
Place the chuck wrench as shown. - Loosen and remove the collet chuck by turning the chuck wrench.
*if you can not loosen the collet chuck, tap lightly the chuck wrench with a small hammer as shown. - Set a new collet chuck.
- Tighten the collet chuck with chuck wrench.【Warnings】
(1)Be sure to insert a blank bur into the collet chuck before changing.
(2)Do not change the collet chuck if the set ring is set on S-direction.(collet chuck is tightly closed)
(3)Do not turn the set ring from R-direction to S-direction while changing.
Posted in: 【1】In General
Nail products
- ▼Nail products
- G5
- G3
- G1
- NP300A/NF32A
- SUP200/SUG12
- UP200/UG12
- UP220/ND7
- ■Bit for nail
- ■Bit for foot
- For maintenance of bit
Industrial products