 |
(1) Start drilling a hole on crystal. |
 |
(2) Using diamond bit |
 |
(3) Mark where you are going to drill. |
 |
(4) For avoiding heat up, please soak the bit in water (not motor handpiece). |
 |
(5) For beginning, please use thin bit. |
 |
(6) The water become cloudy when drilling. |
 |
(7) Use thicker bit step by step, and when it’s drilled 80% of depth, got to backside. |
 |
(8) Same to step (3), drill from backside of crystal(For avoiding crack) |
 |
(9) After all pass through, adjust the hole with diamond bit. |
 |
(10) Finished drilling a hole. |
 |